جهاز نبضي رائع Golden Mask Pulse Ver.1.0. - field test

هذه صور الجهاز

هذا الفيديو

التفاصيل

Work with Golden Mask Pulse Ver.1.0.
Mode1: The metal detector indicates a target with consistent signal (searching head over target). Most efficient when operating with searching frame.
Mode2: After holding the unit over a metal target for 3 to 4 seconds, the target signal dies away. Suitable for operating with small searching heads (20 to 50 cm).
POWER: Searching head power input.
POWER-1: Low power, suitable for small-size searching heads.
POWER-2: Suitable for 1m x 1m searching frames.
THRESH: Signal threshold
SENSE: Unit sensitivity (1,2,3)
DELAY: Sampling circuit delay
DELAY -1: Good unit sensitivity for both small and large metal targets.
DELAY -2: Bad unit sensitivity for small-size targets; good unit sensitivity for large metal targets.
GND: Ground balance; the searching coil is repeatedly lowered to the ground and then up while adjusting the ground balance feature GND at the same time to the complete dumbing out of the ground.
The target depth slightly decreases when Gnd mode is enabled, but it makes hunting on highly mineralized ground easier. GND-0 means that ground balance feature is disabled.
The numbers appearing before the ”COND“ sign describe the possible type of a metal target; 0 to 50 indicate iron and aluminium targets, 60 to 90 – non-ferrous metal.
Technical specifications:
Power supply for 12 elements,
power consumption – 350 mA at Power-1, 600mA at Power-2;
Peak power consumption – 240 W,
Frequency – 350 Hz .

[b]